The signals from electromyography (EMG) have been used for volitional control of robotic assistive devices with the challenges of performance improvement. Currently, the most common method of EMG ...
Department of Chemistry, Graduate School of Science, Osaka University, 1-1 Machikaneyama-cho, Toyonaka, Osaka 560-0043, Japan ...
Vascular tissue engineering is a field of regenerative medicine that restores tissue function to defective sections of the vascular network by bypass or replacement with a tubular, engineered graft.
A low-cost multispectral imager was built using a multiwavelength LED PCB (light-emitting diode printed circuit board), 3D printed housing, and a monochrome camera, and it was controlled via National ...
Figure 1 shows a block diagram of the dynamometer’s architecture. Table 1 describes each of the dynamometer components with the reasons for selection. 1. Shown is a block diagram of dynamometer. The ...
Abstract: A digital control system has been developed for three dimensional (or less) motion control applications using three sets of stepper motors, drive controller and encoder on RS485 4-wire ...
Noise in the visual signal falls as ambient light increases, allowing the retina to extract more information from the scene. We show here that a measure of ambient light produced by the small number ...
Abstract: Stepper motors are used for many applications in industries and robotics where precise control of motor position is essential. The is paper presents the implementation of position control of ...
Some results have been hidden because they may be inaccessible to you
Show inaccessible results